Independent jet high temperature steam generator

Calculate How To

If the plant has only one steam generator (boiler), uses a single fuel, and has a single steam ambient to condensate temperature (usually about 200°F) will be done by heat exchange against a The low-pressure steam cost is then calculated from the high-pressure steam cost as: CL = CH x (HSL – hW)/

Read More

A Study Analysis and Performance of High Pressure Boilers

Steam generator popularly known as boiler made of high quality steel in which steam is generated from water by application of heat. 3.1-STEAM GENERATOR 4.1 Fig- 3 Formation of steam in a boiler from the flue gases and used for heating the feed water The word "saturated" in this sentence, however, indicates that the steam is saturated with heat

Read More

Experimental and numerical analysis of a variable area

Nov 01, 2011 · The experimental ejector cycle with its main components is shown in Fig. 3(a) and (b). A 24 kW electric steam generator (Fulton Boiler works, Ltd.) was used to provide high pressure saturated steam on the primary fluid side of the ejector.The pressure of the motive fluid was adjusted according to the desired saturation temperature.

Read More

3.1 Stationary Gas Turbines

gas turbine drives an electric generator, and the steam from the HRSG drives a steam turbine which also drives an electric generator. A supplementary-fired boiler can be used to increase the steam production. The thermal efficiency of a combined cycle gas turbine is between 38 percent and 60 percent.

Read More

An introduction to steam generation and distribution

Trevithick was the first to successfully use high-pressure steam (then known as "strong" steam). Until ca. 1800, the weakness of existing boilers coupled with the influence of James Watt had generally restricted steam boilers to very low pressures or "weak" steam.

Read More